Porcelain veneer preparation set (for high speed/low speed bending machine)
Packing: 8 pcs/set
Model:BR-12，EX-56，EX-57，EX-58，TR-32，SO-20，TR-D36F，SH 3414
Category:
- 产品描述
- Instructions
- Parameter
-
1.BR-12 : ISo 806 314 001 524 010 is used to remove 0.3-0.5 mm depth at the supragingival margin, i.e., the gingival end, and to extend the mesial and distal proximal surfaces and incisal margins (fenestration).
2. EX-56 : ISO 806 314 552 524 016 The lip surface is ground to a depth of 0.3 mm indicating groove.
3.EX-57: ISO 806 314 552 524 021 The lip surface is ground to a 0.5 mm deep indicating groove.
4.EX-58 : ISO 806 314 500 524 010 bur with a length of up to 15mm, can be used for butt-type and wrap-type incision positioning, easy to control the depth
5.TR-32: ISO 806 314 198 524 014 is the main bur, grinding the remaining tooth tissue at the positioning depth, preparing the incisal end to remove 0.5-1.0mm evenly (butt type), and wrapping the lingual part of the tooth. Grind off 0.5-0.8 mm wide shoulders without corners (wrap-around).
6.SO-20 : ISO 806 314 289 524 008 burs are trimmed along the mesial and distal transition lip to a width of 0.5-0.7 mm, remove the undercut and trim the adjacent surfaces, taking care not to damage the contact points of the adjacent surfaces.
7. TR-D36F : ISO 806 314 198514 024 Finishing each edge, removing the sharp line angle of the preparation and the shoulder without corner.
8.SH 3414 : ISO 658 204 304 514 100 for polishing the incisal and lip surfaces with a slow-speed elbow. (Pay attention to the use of water jet polishing under the vital pulp to prevent heat generation from stimulating the tooth nerve)
Related products
Product Inquiry
Official Account
WeChat ID
-
-
E-mail
-
Contact phone number